NOKIA ULTRASITE BTS HUB MANAGER FREE DOWNLOAD

Change the alarm list options. Check that the unit is properly power or led is broken the front led does connected and the screws are correctly not light up tightened. Problem is caused by bad input voltage, a broken power supply or broken unit. Replace the power supply unit. Replace the door switch box. Click the Legend button to see an explanation of the symbols, as shown in the figure below. Enter the email address you signed up with and we'll email you a reset link.

Uploader:	Kekasa
Date Added:	14 February 2014
File Size:	10.39 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	24928
Price:	Free* [*Free Regsitration Required]

Follow the 2M signal in the network to find the place where AIS replacement has occurred.

Check in the Cross-connections window that the right signal is connected to this interface at both ends of the hop. Replace the BB2x units one by one. Battery only MetroHub Instructions Nokiia the removed unit logically, or replace the broken unit.

Nokia UltraSite BTS Hub Manager C - Nokia Corporation Software Informer.

Click OK to ultrasiye the window. Loop to Interface Line is a far-end loop. The outdoor unit SW is incompatible with the protection mode or the outdoor unit is faulty. AIS is connected to all transmitted Flexbus channels in the receiving equipment. If the TSxx is faulty, replace it. The temperature sensor is probably broken. See also alarm cancelling information in the Cancelling field.

(PDF) Trouble Management of Nokia UltraSite EDGE BTS | safi arshad -

The link is usually faulty or it has configuration errors. Check whether either of the following alarms is Automatic. View the condition bits of the protected cross-connections in the Condition Information frame. Overheated power supply unit Steps 1.

Nokia Ultrasite Bts Hub Manager

MS Instructions Check for open alarms at the far-end device and remove the cause of the alarms. Description The bit error ratio is determined by evaluating the CRC checksum and the frame alignment word. Check if there is a cut or physical damage on the fibre at some point of the fibre link. The incoming radio signal is looped back to the other end of the radio hop. Select loop types for a particular Ultrasitd Radio Interface as required: Cold start active Steps 1.

ultradite Select loop types for a particular FB Channel interface as required: When the correct license is received, install the license using the license manager. If the new TSxx raises the same alarm, check the backplane connectors. The signal to the 2M Flexbus channel from another interface NE is looped back.

For example, if the most severe alarm is a critical alarm, the bell symbol is nkoia. New events are not recorded into the database.

Refresh active alarms and alarm history. Node B is getting its synchronisation from the loop master. Summary The filter options are located on the right hand side of the alarms window.

Wait until the units have been warmed up to the operational temperature range and the power supply unit LED switches from yellow to green. Select Condition Type, Condition 1 and Condition 2.

Note To see the actual status of the cross-connections, you need to refresh the Cross- connections view.

Node A can use this interface as a synchronisation source. The Flexbus BER measurement does not work ultradite this generates the following irrelevant Flexbus alarms: If the replacement unit does not contain the correct license then contact Nokia.